Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramesh kumar k
The only difference is in its usage...
The VTs are used upto 132kV level
the CVTs usage starts from 420kV level and above..
| Is This Answer Correct ? | 10 Yes | 39 No |
Post New Answer View All Answers
How to select the proper VSD to operate high inertial load
You are of electrical field and you are going for software? Why
difference between main metering kiosk and check metering kiosk
Why ground terminal is used in pot meter 10k ohms
how does commutator convert a.c to d.c?
What is online and offline ups? how does it works?
can i use 2000/5A Clamp meter to measure HT cable
What is the difference between DOL starter and star delta starter
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
mccb service sittings be done?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to decide the capacity of accl
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
Can any body tell gulf interview question for experienced electrical engineer ?
what happen if drive input fail momentry at 48.5 HZ frequency?
