Interested to Buy Any Domain ? << Click Here >> for more details...
Why is starter necessary for a three-phase induction motor?
- 37 Answers
- 179236 Views
- BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt, I also Faced
- E-Mail Answers
Answer Posted / abanikanta
Starter is used to reduce starting current.starting current
is usually large because of inertia,charecteristics of
motor winding(at starting slip=1,rotor resistance low
implies less back emf).So at starting we use starter .for
example.STAR DELTA starter.by using a starter at least the
switching is improved which is much important for safe and
longer life time use.simply a DOL can be used for lower
rated motors (up to 07 HP)in this case.for higher rated
motors (up to 15 HP)we can use a star delta connection.a
delta connected motor takes 1.7 times line current than a
star connectd motor.think ! at starting the current is
almost halved .Now a days we use drives (power electronics
products which not only takes care of starting of a motor
(improving power factor) also controls it as perrequirement.
| Is This Answer Correct ? | 56 Yes | 8 No |
Post New Answer View All Answers
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is the purpose of silicon dropper used in battery charger?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what is the difference between oil surge relay and buchholz relay.
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
How to decide cable tray size?
11000volt DG set carnt kaise banvay
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
wat is the first thing dat is needed, 2 lay a cable in some area??
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
The loads are connected with phase and ground then why current flow as the loads ?
Why wind turbines wheels rotate constantly
