Interested to Buy Any Domain ? << Click Here >> for more details...
when any relay trips in any ckt then what type of setting is
there in motor?what is function of relay in that ckt?
- 3 Answers
- 8290 Views
- Finolex, I also Faced
- E-Mail Answers
Answer Posted / ramesh
1st part of the Question is not clear...
Now come to the function of the relay...
It is a device which continuously compares the electrical
quantities in a line (i.e. voltage, current etc.. different
types of relays are provided for different purposes) which
are the output of sensing devices like INSTRUMENT
TRANSFORMERS (CTs & PTs) and if these values in line are
exceeded or reduced to the SET VALUE in the relay (this set
value can be said as normal operating values beyond/below
which the load/consumers connected to the line will not be
safe or equipment gets damaged for different reasons...).
If there is any difference in these two values (values from
the line and set values in the relay) relay senses this
abnormality and sends a signal to the circuitbreaker to
break the circuit. So these abnormal values will not be
reached to the end users/loads. So they are safe....
Is it clear...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are electric motors?
What is the maximum percentage voltage drop (vd%)for a motor control center
grr resistance & contrator malt continuous
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
help me with the question that might be ask on the interview for technical position
How out of step protection relay works?
What is MSL designation of a motor and same may be provided in details.
What are the functions of different probes used in cro?
how to calculate insulation level of transformer?
what is the difference between delta delta and star delta connection transformer? why we use delta delta transformer since it need earthing transformer for grounding?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What Is HO factor in power selection
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
what is the meaning of WYE and DELTA in Electric meter?
