Interested to Buy Any Domain ? << Click Here >> for more details...
Why Power generation in India is at 50Hz while in America
its 60Hz so is there any advantage/Disadvantage of this ??
- 38 Answers
- 88995 Views
- Australia Visa, College School Exams Tests, Fiat, InfoPlus, L&T, NTPC, TCS, I also Faced
- E-Mail Answers
Answer Posted / gautam himmatramka
Well what i feel is that their is no particular reason for
US using 60 hz and we going for 50 hz. But the ratio V/f is
what really matters i.e. any m/c made to operate at a
particular v/f ratio will either be under rated or under
utilized if the ratio goes less and vice versa. With
increased freq., freq losses also increases and so eff.
goes low and o/p is reduced.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
What is the formula to calculate the size of Aluminium and copper cable?
what is meant by impedance & transient protection?
What must be the minimum distance maintained between 2 Generators as per International standards?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
what is the difference b/w UHVDC and HVDC(LIGHT)?
what is efficient motors and how it is different from normal induction motors
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What are the special cables required for explosion proof wiring?
132/66kv sub-station procation ?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
What is sensitivity of a measurement?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
How vfd saving power.
How to see the inductance in a transmission lines
