Interested to Buy Any Domain ? << Click Here >> for more details...
The corona effect is more in
a) summer b) winter c) dry weather d)
humidity weather
- 10 Answers
- 18601 Views
- CPCL, I also Faced
- E-Mail Answers
Answer Posted / munikrishna
c. dry weather
| Is This Answer Correct ? | 0 Yes | 19 No |
Post New Answer View All Answers
what is the function of choke in the flourcent tube lights and why the colour is in white mostly in flourcent tube lights
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
Explain and give examples about VCB?
Air refrigeration cycle works on the
What is transister define the transister ammiter ,base, colector.
Why auxiliary transformers are not connected in parallel in primary stations?
how we can calculate chiller required ampear?
Hello sir i m student of gtu .what is idp.
How we can come to know the substation range,without go through any name plate ?
How would you relate your key competencies to this position?
design a LV scheme for a 15 storied building?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
