Interested to Buy Any Domain ? << Click Here >> for more details...
IN A THERMAL POWER PLANT, WHY IS THE USED STEAM CONDENSED
INTO WATER AND THEN SENT BACK TO THE BOILER, WHY NOT
DIRECTLY REHEAT THE SAME STEAM??
- 12 Answers
- 34148 Views
- I also Faced
- E-Mail Answers
Answer Posted / azarudeen
In the last stage of LP cylinder the out coming steam has
higher specific volume. It is not possible to keep the large
size pipe to travel the steam from one place to another.
hence we go for condensation process. Also further addition
or makeup of DM water can be done only in condenser. Hence
we go for condensation.
| Is This Answer Correct ? | 26 Yes | 5 No |
Post New Answer View All Answers
Explain the terms solid solution, eutectic, eutectoid and peritectic.
What will you check if one cylinder of your engine is not like the others?
For which parts the wahl factor and lewis form factor used ?
HOW TO CALCULATE THE FILTER ELEMENT AREA FOR VISCOUS FLUIDS IN CASE OF PLAETED METTALIC FILTERS
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
Define angular momentum?
Which case we will find maximum pressure and flow in centrifugal pump - circular casing or volute casing ?
"How to check the diode, fuse and bearer switch?"
What are killed steels and what for these are used ?
Which element causes difference in higher and lower heating values of fuel ?
in regenrative cycle why to use two liquid(water&mercury) on steam genration cycle.
What type of pump is lubricator pump?
can i get Mahagenco sample question paper?
Hiii...I am from instrumentation dept in last plant and now in new plant management transferrd me to turbine dcs operation...how and which way I can prepare for dcs operation...time is just 1 month...???
SOMEONE POST THE MODEL APTITUDE QUESTIONS FOR MRF TYRES PLz pLZ pLZ ..Very urgent
