Interested to Buy Any Domain ? << Click Here >> for more details...
suppose we using 3 phase motor of 440 v means what range
of C.T. is require for measuring current ?
- 9 Answers
- 12143 Views
- I also Faced
- E-Mail Answers
Answer Posted / padmanabha prasad
CT range depends on the fullload current of the motor not
voltage. So first find out the motor FLA and based on that
u can select the range of CT(metering). Range should be 0
to FLA*20%)
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the difference between droop mode and ischnorous mode in thermal powerplant?
what kinds of Transformer oil grade is better for power transformer ?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
please send me the L&T Emb. sys. placement papers and entire details of pattren
DG cranking voltage?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What happened when voltage will half value of current ...
what are the possible reaons & remedies if resistance of NGR getting heat up
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
what is the effect of un-synchronized power.
For high frequency application we use which transformer?
how calculate the electrical load for industry and office
How can calculate the rating of a servo stabilizer for given a specific load
Is there any standard guidelines/Criteria to design NGR/NGT.?
what is difference between earthingpits,earthing grid & earthing mess?
