Interested to Buy Any Domain ? << Click Here >> for more details...
If we measure the pressure of Air in duct with the help of
Pitot tube attached to manometer (pitot tube) whose one end
is in atmosphere and one end is in duct and manometer shows
some head whether it is Static head or Dynamic Head or
(Total head=Static head + dynamic Head). and if it is total
head in which static head is zero then how static head is
zero.
- 2 Answers
- 5647 Views
- I also Faced
- E-Mail Answers
Answer Posted / anupam
Pitot tubes are bent in the direction opposite to direction
of fluid flow. on the other end it will show the total head.
static head will be zero only in the case when the two ends
are at equal level.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
what is the job responsilties of Sr. engineer in QA/QC deptt.
How will you classify sliding contact?
which quality steel is better for molasses storage tank? & why? IS 2062 GR A OR IS 2062 GR B
please send me model question papers for DVC Examination diploma mechanical
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
What is the formula to calculate how to find the amperes in 1ton and how many btu
water balance calculation for 1X500 tpd DRI plant?
What is big advantage of fast breeder reactor ?
Name the sheet metal hand tools?
What is max pressure?
Is it the relation between friction and power losses ? is it relation among stress, friction and power loses in cicular ring ?
What pressure is highest L.O. Gravity Head or S.W. of the stern tube circulation
what is the exact heat treatment cycle of IS 4522 Gr6 to get the required properties?
