WHAT REASEAN USE TRANSMETER TWO WIRE & FOUR WIRE
Answer Posted / gajanand solanki
The Reason of using two or Four wire transmitter is of
length of Wire means if the transmitter is mounted at a far
distance from the Controller we will use four wire if it is
near we will use two wire.
Means it is the matter of Accurately measuring the pressure.
Is This Answer Correct ? | 11 Yes | 30 No |
Post New Answer View All Answers
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Explain why plc require in analog input 4-20amp & 0-10 volt?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
How to fix back the valve actuator stem
What is Cavitation in a control valve?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
why fuse block is not used for AI signal?
what is piezoelectric transducer?give an example in power plant n state its principle?
What is the use of double seated valve?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
line up procedure for dp type flow transmitter?
How to Calibrate Interface Level Troll in field
Coal mill Instruments Equipments for cement plant And process diagram ?
Explain pH, Conductivity.