Answer Posted / manish meena
bucholz relay is oil and gas operated protective relay
which is mounted on the pipe between transformer tank and
conservator
so when during any fault result in gas formation this will
cause the oil level in relay to drop and makes the alarm
contact to operates if the fault is very severe then the
gas formation will be very large due to this there is
further decrease in level of oil in relay..due to this trip
contacts are operated and finally the transformer is
disconnected from the supply....
Is This Answer Correct ? | 41 Yes | 6 No |
Post New Answer View All Answers
how to extend relay operating timing in 24V dc relay card (without using Timer )
WTA used cb?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What do you mean by ratio correction factor of instrument transformer?
What is called grain-oriented laminations?
How to detect voltage vector shifting in interconnection protection.
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
What do you mean by a phase angel of instrument transformer?
Why are the cores of large transformers built up of circular transactions ?
Difference between transition and diffusion capacitance
Is vtg is controlled by the resistor? if else how much?
what is the principle of operation of CFL ??
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
WHAT IS MEANT BY TV TERMINAL IN 500MVA TRANSFORMER?
How can calculate the rating of a servo stabilizer for given a specific load