Interested to Buy Any Domain ? << Click Here >> for more details...
A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
- 20 Answers
- 22759 Views
- I also Faced
- E-Mail Answers
Answer Posted / ze khan
the motor will not burnt,this is correct any confusion than
wil performed practically ok.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to measure current and voltage in an ELV circuit
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
how maney type tempereture measurement ?
why r we using shell transformer for low voltage
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
why not starting switch first connect in direct on line starter?????
When is lag lead compensator is required?
How to do stting of vl250 siemens MCCB
what about the power of wattmeter at starting and loding?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
what is the total power generation in india?
Difference between rating factor of cable and derating factor of cable?
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
