can you give main difference between ELCB And RCCB?
- 38 Answers
- 161102 Views
- MCB Bank, Reliance, Wipro, I also Faced
- E-Mail Answers
Answer Posted / manas
ELCB-- earth leakeage circuit breker
RCCB-- residual current circuit breaker
MCB -- minuate circuit breaker
ELCB-- for earth leakage protection
RCCB-- residual current protection
MCB-- overload protection
ELCB
when leakage of current from phase to earth occurs than
it operate
RCCB
it operate when there is a difference of current between
two phase.
MCB
it operate when there is a overload occures
practically
RCCB=ELCB+MCB
| Is This Answer Correct ? | 23 Yes | 9 No |
Post New Answer View All Answers
Explain bypass capacitor?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
At what speed 1 HP motor can run an electric car of weighing 400 kg?
what is the differebt between ac and dc fuse?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
State The Difference Between Generator And Alternator?
why asa method ZPF method is more accurate than ASA method?
what is draiv work
What is the differentional relay...what is the work of this in power Tx. how it is works..
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
How to setting the volume of RTCC panel AVR (11kv) controller
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
