Answer Posted / amandeep singh
All the mentioned are the networking devices for connecting
different computers, other peripheral devices (printers,
scanners), different network with each other.
SWITCH:
Switch is a device to connect different computers with each
other in the same network. One advantage of switch over hub
is it do not multicast the data/message. It is due to MAC
Table maintained by Switch. Works on Layer 2 of OSI Model.
HUB:
Hub is also a network device but comparing to Switch its
data transfer speed is slow because it multicast the data
in the network and after getting the destination host it
deliver the data. Works on Layer 1 of OSI Model.
ROUTER:
Mainly used to connect different networks which have
different IP address range. From its name its clear that it
route one network to other network to make communication.
One good advantage of router is that is also works as
firewall in your network.
A router may create or maintain a table of the available
routes (networks) and their conditions and use this
information along with distance and cost algorithms to
determine the best route for a given packet, so data
transfer is fast. Works on Layer 3 of OSI Model.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Describe profile in terms of networking concept?
Describe a recent short term stressful situation and how you managed it?
Is there any website? Which can theft or watch any system or computer hardware drives(memory)while they are accessing Internet.If it is avilable what is it? Please answer me.Advance thanks
How would you monitor and maintain the local area network, email, internet & intranet systems to ensure data security and prevent occurrence of faults?
if one server is down, whenever restart the machine we get ok prompt what is the problem?
Tell me what happens when you use cables longer than the prescribed length?
how to check veritas install or not
Can you please explain the difference between hub and a switch?
What is mac addresses?
Do you know what is the maximum segment length of a 100base-fx network?
Explain the difference between csma/cd and csma/ca?
how to add additional instances sar r3, what are the steps to take server is down.
senario: There are two switches connected via trunk port.One end station is connected to each switch via access port. All the ports are in same VLAN.All the ports have same speed 1Gbps.Start sending 1Gbps traffic from one end station to other. Determine percentage of traffic received by destination end station.
Purpose of TTL. How it gets modified.
How frequent the STP information will be exchanged