Why dose an electric meter record KVA when there is no load
on a 500 KVA transformer
Answer Posted / chandrasen mourya
This is related to the iron losses & copper losses of the
Trafo. Iron losses are constant ie from No load to full
load. Copper losses varies depending on the load current.
Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
Is there chopping current in resistive circuit
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
what is difference between bus coupler and auto transfer switch
what is the difference between electrical and electronic choke?
How to calulate Locked rotor amper(LRA) for compressor type motors?
What are the advantages of nichols chart?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
what is droop control?
What is meant by bus bar protection?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
what are safety measures in /control in diesal engine/ explain them?