which is type of thermocouple is used to measure 1000deg?
- 9 Answers
- 10861 Views
- I also Faced
- E-Mail Answers
Answer Posted / jignesh
we can use four types of termocouple instruments like
R,S,J,E. this all types of thermocouple cover 1000 deg.
tekp.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
what would be the minimum flow rate that we can measure on rotameter..?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How it the difference between force balance system and dispalacement balance system?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
what is easiest way to read STL language in PLC?
How to calibrate level transmitter with use of HART?
how to design orifice plate?what is the equation?
what is sil (safety integrity level
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
what is scale factor of proximitor & unit of the vibration.
What is the cascade control
