what is purpose of governor in desiel engine...
Answer Posted / mallayya
Purpose is to controll the flow of fuel to the engine
Is This Answer Correct ? | 24 Yes | 5 No |
Post New Answer View All Answers
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is the turbine and how does it work?
How do you calculate cooling energy?
What are the different types of brakes and explain them?
Dear sir/madam, plz sand me techanical test question (mechanical)
WHAT IS DENSITY OF AIR AND PETROL MIXTURE IN 2 STROKE S.I.ENGINE
What is the difference between stalling and surging in rotary compressions ?
What is an ortographic drawing?
What are the causes of dirty lubricating oil?
pl. send me jr.engg.model question for rrb malda.
There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?
What is the use of gravity disc?
how to calculate steam velocity on tg i/l ?
why desuperheater tubes are bend in shape
What is a torque converter?