Answer Posted / praveenkumar s
by using "transuducer" we can convert any electrical signal
into 0-10v and 4-20mA
Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
How does the phase sequence controller works, how it identifies the phases? confirm working principle
Define bibo stability.
What is the universal motor?
What is the difference between vector surge relay (78) and Pole slip relay (98G)
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What is the maximum operating temperature for a thermoplastic insulated cable?
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
What are the different types of controllers?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
how to calculate cable size in diffrent loads?
Write down the brushes of a de machine.
why on delay timer used for fully automatic star delta starter?