Answer Posted / gova

Hi

If it is a single phase tfr,then (Voltage*current)/1000 =
KVA

If it is a three phase tfr,then
(1.732*voltage*current)/1000 = KVA

Cheers
gova

What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2

2055

---

when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....

1752

---

Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.

1906

---

what is RNG in the DG synchronizing by PLC?

2113

---

Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.

2124

---

66kv under ground cable how to layaing in ground any special case two ckt r runing

1966

---

What is the difference between diode and a transistor in terms of the direction of current flow?

2198

---

we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V

1849

---

54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?

2179

---

Earth bits close or open. Which is correct

1918

---

How do we calculate the Out put voltage of generator, after the excitation is being given?

1911

---

I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in

1889

---

How PADO software increase the efficiency of power plant?

6461

---

What is Tachometer used to measure?

1228

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

784

---