how would you troubleshoot a situation where there is no
display on a monitor?
Answer Posted / prakash
first check the VGA card connected to cpu properly .
if any beep sound then check the RAM .remove ram from cpu
clean it by cloth then reinsert it . before inserting ram
power on cpu and check motherboard if any beap sound MB is
fine . if no beep sound without ram then problem with MB
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
what is basic of networkin ?2.what is main topik of networkin ? 3.how installed the software and drivers ? 4. how to connect the pc and net?5.what uses of protocol in networking,and tell main proto of netwo
How to create dynamic users on simple Asterisks server for simple extension based x-change?
Which layer is used to run services like FTP, Telnet etc.
Differentiate between IEEE 802.3, IEEE 802.4 and IEEE 802.5 standards.
What is tdm?
Explain Difference between congestion control and QoS(or Quality of service)
What is the minimum and maximum length of the header in the TCP segment and IP datagram
What is a Multi-homed Host
Why do data link layer protocols position the checksum in the trailer and not in the header ?
What is NVT (Network Virtual Terminal)
1. What ports does FTP traffic travel over? 2. What ports does mail traffic utilize? 3. What ports do HTTP and HTTPS use? 4. Why is NTP required in an NFS network? 5. Name some common mal software on the server side 6. What is CPAN? How do you access it? 7. What is PEAR? 8. What advantages does mod_perl have over a perl CGI? 9. What is required to do SSL in Apache 1.x? 10. What is Tcl? 11. What is a servlet engine/container? 12. What is BIND? 13. Name the steps to setup a slave zone in BIND 14. Name the steps to setup a primary zone in BIND 15. What commands would you use under Solaris or Linux to modify/view an LDAP tree?
Explain Wireless networks.
What is a transparent bridge?
Define Explore a world of satellite solutions?
Define Consumer Satellite Products