Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gova
Hi
we are encouraging the diff.relay not to trip for external
fault or through fault by providing restraining or biasing
coils.It is a single coil which is divided into two coil
having same number of turns.
If there is any unbalance in this coils,then the current
will flow through the operating coil and trip the
circuit.this unbalance will come when there is a internal
fault or CT mismatch or CT saturation etc
Gova
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
what is RFCT and Insulgard Relay & It's function?
what is the need of starter in tube light and what type of starter is used in that?
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
in conventional fan regulators how the current varies with speed?
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
what is the difference between ac motor and dc generator
Which device of PlC does share load between DG sets when DG are running in perallel?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
What is sink and source?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
Refernce currents are to be generated using refernce cueernts how can this be done
what is acceptance test in electrical engineering.
