Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / j.kesavan
Dar means dielectric absorption ratio test in HT
machines.HT megger reading 1minite/30second reading is Dar
test.
| Is This Answer Correct ? | 37 Yes | 6 No |
Post New Answer View All Answers
Please give me a erda placement paper
Write the programming software name for LG, SIEMENS,Messung,AB
What do you mean by cogeneration? What its working principle?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
66kv under ground cable how to layaing in ground any special case two ckt r runing
What is meant by sag?
How to address the servo drive for motor
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
How to calculate the heat load for a electrical room
how to synchronize 3 phase slip ring induction motors of different ratings.
what is the difference b/w UHVDC and HVDC(LIGHT)?
