Interested to Buy Any Domain ? << Click Here >> for more details...
Is it possible to get earth resistance value"zero" Ohm
practically???
If yes,which type of earthing???
- 9 Answers
- 16974 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / janakiramankesavan
should be maintain below 2 ohmes.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
HOW TO CALCULATE THE VT SIZING?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
How to calculate Air conditioning capacity for a telecom BTS shelter?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
How to see the inductance in a transmission lines
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
Is there any abbrevation for STUB in Stub bus protection
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
