Answer Posted / felixraj
directly connecting the nutral point to earth without any
Resistance. practically zero resistance is not possible
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
Explain the working of any one cutting machine
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
Why is ignitor used in sodium vapour lamp
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
tell me some type of questions throught which i can prepare for exam and do my best
Transformer how to maintaince a check b check c check d check
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
explanation of mesh bus bars
Formulae for calculating the transmission line losses for different voltage levels
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
