Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sprajapati21
If i have x dimention material and i applied force on it
than the dimention increase x + l
and origanal dinmention x
stain = deformation/original dimention = l/x
and stain have no unit of measurement
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the critical speed. Compare the critical speed of hollw shaft and solid shaft.
HOW CAN WE MEASURE THE L SHAPE SURFACE OF THE MOMENT OF INERTIA AND SECTION MODULUS
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
Why should a chain drive be used over a belt or rope driven drive?
alignment formulae for any two shafts for shim correction
What are the usual checks when induction motor is running?
Which material grade is better for low temperature application upto -20 deg C either IS 2062 GR B OR IS 2062 GR C ?
why with the increase of pressure latent heat of steam decreases?
What causes diesel engine trouble when using heavy oil?
What type of pump is lubricator pump?
What is the difference between P11 & P22 pipes?
Where pneumatic system is used?
What is meant by shell and tube heat exchanger?
how material removal occurs only in workpiece not in tool during an EDM process?
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
