What will happen if supply to three phase motor is given
wiyhout inerting rotor in it?How much current it will draw?
- 5 Answers
- 6269 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendran
With out the presence of the rotor there will not be any
back emf (In opposition to the supply voltage)....
So the stator winding will draw very high currents from the
mains and the fuses will blow immediately....
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
how to prepare the technical test
which capacity of RCCB used for five thousand watt electricity load?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
how to select energy meter? have any calculation?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is electrical cable termination
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
What is maximum power transfer theorem?
what is a bus post insulator? explain its application in a substation.
What is Auto Mains Failure Panel & Auto Synchronizing Panel
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
What is gain margin?
If not into production, how far did you follow the design and why did not you see it into production?
