Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between AUTOMATION AND
INSTRUMENTATION?
- 7 Answers
- 38562 Views
- I also Faced
- E-Mail Answers
Answer Posted / aatif alvi
automation is the term used to control and monitor any
industrial system with a control loop.
And instrumentation is a raw term used for the instruments
that are used in any control loop, DCS.
| Is This Answer Correct ? | 68 Yes | 5 No |
Post New Answer View All Answers
What is sensitivity in vibration probes..?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
How will you calibrate PID controller? explain with example.
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
Explain working principle of lvdt?
If P will increase then what will happen with PID?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
can we create an interrupt in plc through scada?
What is the minimum rating availalbe for weld neck orifice in market?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
What is the purpose of LO Overhead tank in turbines.
What is profibus?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
