Interested to Buy Any Domain ? << Click Here >> for more details...
I want to take temp. data from recorder to computer. Which
communication system is best from this option(Rs 232-
485/ethernet/USB)?
- 3 Answers
- 6665 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav kale
It all depents upon your computer or monitering Equipment
distance and also the purpose i.e.to control or to monitor.
the distance limitations and speed of responce is as
follows for
1)RS 232 --distance =20 feet--speed limited to KBPS
2)RS 485 --Distance upto 1500 feet --Speed Limited to KBPS
3)ETHERNET PORT ---DISTANCE UPTO 500 METERS --sPEED LIMITED
TO 100mbps..BUT now a days it is enhancet to GBPS provided
that the connectivity should be Fibreoptic
4)I haven seen instruments with USB compatibility ,but we
can convert many ports to USB
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
how many type conductivity sensor ?
please tel me the calibration of pneumatic controler.
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
Explain why plc require in analog input 4-20amp & 0-10 volt?
how to calibrate corollaries (Mass flow meter)?
why we are not using the turbine flow meter in the steam service?
In apron feeder how TPH is calculated?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
wich is coming the first HAZOP OR SIL
the output of the common trasmitter protocol in qatar gas are the following
