Interested to Buy Any Domain ? << Click Here >> for more details...
How can calculate the efficency of the rectifier. input
240V AC, current 5 amps,P.F 0.98, Output is 54 V DC,62.6 A.
- 10 Answers
- 26971 Views
- I also Faced
- E-Mail Answers
Answer Posted / stanley electrician
Dear Mr.swapnil,
you have given the formula as P=VI*PF for both
input and output.
You should remember that the pf is not considered in the
DC (output of rectifier).
MY PROBLEM IS, OUTPUT POWER OF THE RECTIFIER IS GREATER
THAN INPUT. SO THE EFFICIENCY IS MORE THAN 100%. But the
efficiency must be with in 100%.
Any way thank you for your answer.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is the dependency of stiffness on load angle??
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Details about Flux Compensated magnetic Amplifer starter for motors
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What are chief characteristics of state-space method and its techniques ?
what transformer we used normally and upto which kva?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
How to connect the chemical earthing and complete process tell me plz
Give some differences between open loop and closed loop control systems.
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
