Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / arun_sekar_1986
Electric Arc is nothign but discharge of current from
conducting medium through a gas filled device.
Ex: Vaccum Circuit Brekaer, SF6, ACB.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Star Delta Diagram with full description
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
What is center gravity load in substation?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
difference between high and low impedance BUS BAR relay??
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
What do you mean by a phase angel of instrument transformer?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
what is difference between bus coupler and auto transfer switch
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
Why Neutral Isolation is required?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
What is the two pole structure?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
