Interested to Buy Any Domain ? << Click Here >> for more details...
how to diffrentiate between ac & dc motors from a distance
- 5 Answers
- 24672 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.silamparasan
We can identify the motor its A.C or D.C by their physical
appearance. Basically the A.C motors are shaply in round
because it has only stator winding as 4pole or 6pole. But
the motors are shaply in rectangle because it has poles as
well as interpoles to compensate the flux leakages. So we
can find out a motor it is A.C or D.C by their physical
appearance.
Anybody kindly give me a feedback about my
answere.
| Is This Answer Correct ? | 9 Yes | 21 No |
Post New Answer View All Answers
When is lag lead compensator is required?
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
What is the abbreviation of NGT panel
What is the exact formula for one weber of magnetic flux?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
how does a submersible pump work..?
How to Make relay co ordination chart for a Electrical power distribution of a plant
How to calculate the sag on transmission Lines.
What is Instantaneous Earth fault relay,how will work
What's the difference between non break power supply and non break non short break power supply
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what is high and low cut off voltage of BB and DG at SPS????????
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
