the resistance of wire having length X M is R OHEM if i
streched the wire to dubble length what will be the
resitance
- 3 Answers
- 3629 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil singh
As given R1 = L/A ohms
Lenth of cable = L Meter
and Cross Section Area supposed = A sqm
if the same streached to double length
now length of cable = 2L Meters
and Cross section area = A/2
Hence new Resistance of the wire will be R2=2L/(A/2)
R2 = 4 L/A = 4 R1
i.e. four times of earlier
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How can we checked Killo Watts of Motor & Alternator?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
How can we measure the residual voltage in dc machines?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
Define settling time.
What is the difference between isolators and electrical circuit breakers?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
Air refrigeration cycle works on the
Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks
In dc ckt. 24v or 110v, which one is more efficient and why?
What is step signal?
In parallel operation time both NGR’s close or not close if both close what will happen
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
