Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Earthing and Neutral?
- 13 Answers
- 27458 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandru_williams
In simple words we can say that neutral is one which is
used to close a given circuit and earthing is one which is
used to divert short circuit current of fault current to
the ground there by avoiding life loss.
Earthing is at zero potential whereas neutral is never at
zero potential . there would be very light potential.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
how we design a pannel to start 10HP motor with the help of star delta starter?
List few applications of d.c series motor?
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
advantage and disadvantage of team work?
Why auxiliary transformers are not connected in parallel in primary stations?
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
why is using sensor?what is differece between photoelectric and proxmitty?
What are your future plans for the company if permanently employed?
ROC converges if poles and zeros lie inside a. Origion b. Z=1
how cables go in and come out for distribution from the feeder pillar box?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
what is the responsibility of C license holder in industry?
