Interested to Buy Any Domain ? << Click Here >> for more details...
if two bulb of 50w &30w apply in series having 230v the
which bulb glow bright ,why
- 10 Answers
- 20317 Views
- I also Faced
- E-Mail Answers
Answer Posted / senil
the lamp which is connected near to phase that lamp is
glown bright........
| Is This Answer Correct ? | 0 Yes | 30 No |
Post New Answer View All Answers
What are the differences between single phase and three phase?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
why you don not show protection and type of isolation in key single line diagram?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
what is meant by power and distribution transformer ?
wht is embedded systems? what is new inthis field?
how to select proper cable for ct wiring so that drop within the limit.
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
What happen in ups if phase reverse?
Hoe do calculate the Cable size for Amps rating ?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
why cable i burning without tripping. how can protect led street lights
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
