Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / natarajanramkumar
PowerFactor of circuit may be defined as:
a.The ratio of resistance and impedance=R/Z
b.The ratio=Watts/Voltamperes=True power/Apparent
power=V*I*costheta/V*I.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
two way ckt diagram can be drawn by how many ways? give diagram
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
Differentiate between induced emf and self inductance?
What is the function of the generator exciter?
what is the id1 & id2 setting in differential protection relay of CSPC?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is vacuum circuit breaker.define with cause and where be use it device?
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
What is inverse definite minimum time lag relay? Where is it use?
Which device is used for the source of emission of electrons in a crt?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
How to decide whether A / B / C / D curve type MCB should be used?
