Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dany
SUPRIYA, it is a good answer ,but can u clarify what is the
significance of this form factor
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how harmonics generated in induction furnance? how minimise it?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
How to calculate mf when meter equipment and meter are connected
does a DG set has low fault level as compared to that of a transformer.If yes then why.
Should power factor be low or high?
substation+ plc system
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Cb closed condition if there is a tcs fail whether cb will trip or not
