Interested to Buy Any Domain ? << Click Here >> for more details...
what is CRGO Transformers?
- 6 Answers
- 31955 Views
- MSETCL Maharashtra State Electricity Transmission Co Ltd, TATA, I also Faced
- E-Mail Answers
Answer Posted / gtmanikandan
GRGO means Cold Rolled Grian Oriented Silican Steel
Lamination, it is Magnetization loss is very small comper
to other steel lamination plate
| Is This Answer Correct ? | 9 Yes | 9 No |
Post New Answer View All Answers
what is the working principle of a DG Set, Alternator, & exiter
Define de-sensitivity?
Z transform is use when system is not a) converges b) diverges
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
Why earthing is necessary for any equipment?
what are symmetrical and non symmetrical components in electrical installation.
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
