Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of choke on tube light fitting
- 37 Answers
- 79637 Views
- Bhel, Dharma, HSBC, TCS, I also Faced
- E-Mail Answers
Answer Posted / radhakrishnan p.n.
answer 3 very correct
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
what is saturation kit?which use above 15 kw motors panel side.
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
Define cut-off rate?
state the disadvantages of carbon filament???
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
