Why we use 250 ohm resistor in series with HART protocol
communication?
Answer Posted / debasish sarkar
For Load Resistance.
Is This Answer Correct ? | 43 Yes | 29 No |
Post New Answer View All Answers
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
In apron feeder how TPH is calculated?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
what is the working principal of pribe
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
How to interfacing microcontroller with a DC motor
How do bending tubing provide better measurement than using tubing fittings such as elbows?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
what is the procedure of O2 sensor(ABB) calibration?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .