Interested to Buy Any Domain ? << Click Here >> for more details...
why transmission voltages are in multiple of 11kv?
- 10 Answers
- 26702 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant rajak
Beacuse of the form factor in AC system which is 1.111111
therefore transmission in Av system is multiple of 11
| Is This Answer Correct ? | 76 Yes | 20 No |
Post New Answer View All Answers
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
why generator efficiency is more in swinburnes test?
What do you mean by a voltage transformer?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
what is the maintaining Cf in UPS.
what is the requirement regarding earthing of Single conductor with AWA
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
ROC converges if poles and zeros lie inside a. Origion b. Z=1
how to get bearing & winding temperature of an induction motor?
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
