Answer Posted / dave.vimal
PF Is
1.Cosine angle between voltage and current.
2.IT IS THE RATIO OF RASISTANCE AND TOTAL INPEDNCE OF THAT
CIRCUIT AND DENOTED BY COS PHI.
P.F. = R/Z
3.RATIO BETWEEN ACTIVE POWER AND APPARANT POWER IS CALLED
POWER FACTOR.
POWER FACTOR= ACTIVE POWER/APPARANT POWER
= VICOS/VI
If the load is inductive,pf is lagging.
If the load is capacitive,pf is leading.
If the load is resistive,pf is unity.
pf can be found out from the power triangle
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What is ST and specify its range of voltage.
Give two basic speed control scheme of dc shunt motor?
what is the function of bearing in dc mchine" and where it is placed
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
if a.c supply is given to the motor,, what happen?
Which cable is use for rtcc control panel
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
What is a diode?
What do you mean by a phase angel of instrument transformer?
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
How do I calculate/select Droop CT ratio for various capacity of generators?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
what is the difference between b c d curves on mcb