Interested to Buy Any Domain ? << Click Here >> for more details...
Sparking occur when a load is switched off because the
circuit has high
a.) Inductance b.) Capacitance c.) Resistance
d.) None
- 14 Answers
- 43497 Views
- Biwta, BSNL, CDS, DMRC, Infosys, SSC, I also Faced
- E-Mail Answers
Answer Posted / anu
could u reason out ur answer
| Is This Answer Correct ? | 12 Yes | 9 No |
Post New Answer View All Answers
can you give me example of igbt drive circuit... i still not under stand how it can be design with certain equation using mathlab program...
3-4 ques of instrumentation : data based.
Amplitude modulation is basically a A Summing of two signals B Multiplication of two signals C Subtraction of two signals D Non-linear process
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
Why iceo >> icbo?
Why the degree of valve plugs and valve seat is slightly different I control valve trim design
Explain why are the 2 input terminals of an op-amp are called as inverting & non-inverting terminals?
What is the use of all pass filter?
what procees happens when u try to open a web page
1 *2 1*3 *2*4 1*3*5 *2*4*6
details of siemens automation systems.
What is difference between FR & GB over IP
what FET were we use its
WHY RECIPROCITY THEOREM IS MAINLY USED IN ELECTRONICS
draw the interface diagram of 8085 microprocessor having input ports at 23H, 2FH, EFH, and output ports at 44H, 2FH, EFH, and FFH using NAND gates only.
