Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramniveth
there is no CT to sense DC current
but it can be sensed by using two sets of rectifier units
placing one input to primary side of transformer and the
other in secondary side of the transformer.
but this is too expensive
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
What is the difference between a fuse and a breaker?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate the Harmonics losses in terms of cost/unit.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
How is the speed of a DC shunt motor related to the armature current?
he compression ratio for a petrol engine generally lies between
send me all basic electrical question and answers
what is kvarh? Please define it With calculation General motors ?
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
What is the formuala to calculate the rating of motor protection circuit breaker
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
