if u have to give support in 1 km long bridge,where u will
give it & how many?
Answer Posted / guest
if we will use the proper calculation of the bending moment
and where the sagging is more according to the material
before load is added.
if after putting support at the end point in the prototype
sagging takes place , a third support is added.
again, if sagging takes place two more supports are added
one one each sag points
therefore total of 5 supports.
i guess..
is it right ??
if anyone can tell me?
Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
What is a steam turbine diaphragm?
What are the causes of emergency stop in a steam engine?
What is meant by shell and tube heat exchanger?
How many litres did 1 cubic meter contains?
Why head of a centrifugal pump is independent of density of fluid?.
What is net refrigerating effect of the refrigerant?
One litre is equal to ________cm3 ?
how can we calculate the size of bearing with the size of plummer block?
Is it possible to make common ducting for Induced draft boiler with Forced Draft Boiler? Induced Draft Boiler is having Agrowaste type and Forced Draft Boiler is of Oil Firing type.
i am looking for a 4 kw immersion water heater /in the USA is this a 220 system or 240
What does green field project mean?
What is the thermal efficiency of a diesel engine?
What is blower? Partlist of blower.
Name four important properties of a good refrigerant.
Name the only five parts of lathe machine?