Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER?
WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN
TRANSFORMER?
- 5 Answers
- 26052 Views
- ABB, Nissi Engineering Solution, NSL Sugars, I also Faced
- E-Mail Answers
Answer Posted / bijay
well things are explained well above.
i wud like to add something
WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN
TRANSFORMER ?
Ans:-First thing under an abnormal condition(during fault)
the neutral point of trafo rised above the ground potential
and attains a positive potential,hence a current will flow
through the trafo neutral to the ground (mostly the trafo
neutral is earthed with or without a NGR.
As a whole the bottom line is trafo neutral will rise to a
potential which is not desired,protection against the same
is designed,which cut of the supply it this condition
prevails for a longer time( this time is descided at the
time of designing the system.
| Is This Answer Correct ? | 13 Yes | 6 No |
Post New Answer View All Answers
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
what is the solution for meger test failed the MV cable?
What is order of the system?
What are protections for dty type transformers
what are all the components required to assemble solar panel other than pv cell?
A low wet bulb temperature indicates
how generator load test is conducted?what are the steps?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
why it is so called as xlpe(cross linked poly ethyline) cable?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
In a single how much maximum current and watts using
state working of halogen lamp?
