Interested to Buy Any Domain ? << Click Here >> for more details...
when we given 3 phase supply to ups system, but out put
comes with 3 phase + neutral how it possible? pls explain.
- 3 Answers
- 8153 Views
- Enzen, Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / logesh kumar.a
the input given system has star connection .so it has 3
phase & a neutral
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
What are the advantages of autotransformer?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why not starting switch first connect in direct on line starter?????
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
Compare salient pole and cylindrical rotor machines.
what is earth pit , how we can measured it, what earth rods reference
What is the operating principle of turbo-generator.
How much minimum insulation required between 11kv/3.3kv transformer windings?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
What is effect of over voltage and under voltage on ACB
