Interested to Buy Any Domain ? << Click Here >> for more details...
What are the conditions considered while evaluvating MARGIN
OF SAFETY for newly designed mechanical components....? or
Explain its steps...??
- 3 Answers
- 6689 Views
- I also Faced
- E-Mail Answers
Answer Posted / saki2mi
margin of safety is:
MS = UTS/(stress*FS)-1
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
If a dimension is given as SC parameter, is supplier allowed to use full range of tolerance specified in drawing without proving capability?
DAE Mechanical engineering interview questions
sir,i am golng to attend BHEL supervisor trainee personal interview on 11 sept.anyone share me that how could i perform well in interview& what they would expect from me. thank you.
what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??
current rating of a 3 phase dg set is 20 amp, but what will be the per phase current for single phase supply?
What is churning effect of turbine
i have been selected for the HAL interview? what type of questions can i expect? technical or personal? pls help me in this regard and mail to sankar_aji@yahoo.co.in
What is meant by newtonion and non-newtonion fluids?
please send me samples of tech. & aptitude tests
how to prepare for bhel et interview
Question regarding property of Critical Path?
a three phase squirrel cage induction motor runs slow? list all possible reasons for such fault.
What is g.i.?
why with the increase of pressure latent heat of steam decreases?
please send me rrb question papers of SE MECHANICAL
