Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sennapparajan
well friend. both of them resistive load. if u have doubt
just check in prctically.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Why arc quenching is used in Diode ?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
what is POTT and PUTT explain?
what is the meaning of the symbol << >> put in transformer drawing
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
we specify current in case of feeder but in case of distributor voltage, why?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
state the working of discharge lamp?
what is the importance of earthing system on the generators big capacity and small?
why only exciting current is shown not primary current in transformer???
