Interested to Buy Any Domain ? << Click Here >> for more details...
what r the earthing required for commissioning of D.G set?
- 5 Answers
- 10953 Views
- I also Faced
- E-Mail Answers
Answer Posted / shri..
The D.G set required total four earthings, two for earthing
& two for nutral.
| Is This Answer Correct ? | 22 Yes | 4 No |
Post New Answer View All Answers
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
What is the difference between Encoder and Resolver?
How many gap between finger contact in a.c.b. and v.cb.?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why is remote backup preferred to local backup?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
why the rotor current becomes in steady state during high slip region? please verify with equations.
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Why the power factor improvement is so important in industrial loads
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
