Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / loganathan
rotor shaft mid point and bearing circle mid point should be
match.
rotor shaft rotate with bearing without any fraction and
sound ie, this have motor alignment is correct
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
Operation carried out in thermal power stations?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What are the significant parts of dc generator?
Transmission through a short line depends on
Define super node?
what is the chemical name and formula of refrigarent R-134a.
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
where we use the SFU & FSU?
Why to keep capacitor bank off while generator running.
What is the dependency of stiffness on load angle??
Define cuttoff frequency?
