what is the back ground of transformer working? applying
voltage to primary and emf inducing in primary and
secondary? how it is possible? please answer me with
scientific approach?
Answer Posted / prashant
refer BL THERAJA VOL2
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is meant by vector group of a transformer? How can it be derived?
why we can use 1 to 5V dc
State and define ohm’s law?
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
do we use links in a dc circuit?if so what s its use in it?
11 kv input, 66 kv input advantages
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
how to calculate cable size in diffrent loads?
What is the function of capacitor in electrical circuits?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
State nyquist stability criterion.
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
What is open delta Xformer? It's adavntages & Use?